DASCOM Americas 2610 Návod k obsluze stáhnout pdf (Strana 61)

Tally Dascom 2610

2. Static assignment using the operator panel:

◆ Press < Setup >, then < Menu >.

◆ Press < Next > until the I/O selection appears. Select < I/O >.

◆ Press < Next > until the ETH-INT selection appears. Select < ETH-INT >, then< IP Addr >

◆ Enter the value for Octet 1by pressing < OCTET 1 >. Use the forward and backward

arrows to increment/decrement the number. When finished with each entry press

< Set > which will set the currently displayed value. To exit out without changing the value

press < Exit >. Enter the Octet 2 value in the same way, pressing < OCTET 2 >. To get to

Octet 3 and Octet 4, select < Next > and then select <OCTET 3> and < OCTET 4 >.

◆ Enter the default Gateway and Subnet mask in the same way. < Gateway > is available

from the screen you are returned to. Press < Next > to select < Subnet >.

◆ Enter the IP address get method under the selection <IP Get M>. Select <Static>.

3. BOOTP IP address assignment:

◆ Press <Setup>, then <Menu>.

◆ Press <Next> until the I/O selection appears. Select <I/O>.

◆ Press <Next> until the ETH-INT selection appears. Select <ETH-INT>.

◆ Press <Next> until the IP Get M selection appears. Select <IP Get M> Select <BOOTP>

◆ Obtain the Ethernet MAC address by printing the “Current Settings” configuration page,

Turn off printer.

◆ Configure your BOOTP server with desired IP address and MAC address.

◆ Turn on printer.

◆ Verify that the printer network interface received an IP address by printing the “Current

Settings” configuration page or in the operator panel menu.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 128 129

Žádné komentáře

DASCOM Americas 2610 Návod k obsluze Strana 61